A single skinned, two into one, has got to be lighter than the ST's double-walled system and I guess you'll have binned the original shocks by now. Obvious candidates would be the wheels and exhaust system.

I reckon if you can knock off some weight it's going to make a significant difference to performance. If you haven't watched his series of vids on their Street Twin development then you should. However George Milburn, the main man at TEC Parts, managed to squeeze even more than that from the first generation, largely by fitting the TEC camshaft. A change in camshaft design added a few more horses in the updated version. You may well know this but the original Street Twin was restricted to 54/55 bhp largely by the camshaft. I did not feel any noticeable change in performance. I placed it inside the airbox snorkel, which you've whipped out. I know the air sensor needs to be located away from any significant heat source. There is now some popping on the over-run, which I also like. I've fitted TEC end cans and the two mods give a louder and deeper exhaust note. My others have carbs, which when set up properly, give a more sharp and responsive throttle action. It's the first fuel injected bike I've owned. The most obvious improvement was in throttle response, it's now noticeably sharper and the slight delay I felt before has gone. It's very well made and straightforward to fit (in both ways superior to the TEC Parts X-pipe).

It weighs approximately half as much as the cat, but as this bike is so fucking heavy I don't notice any benefit. I replaced the cat on my Street Twin with an X-pipe from Motone. Join me on this classic Cafe Racer journey.

I want to see what Triumph would have done with this bike if they didn’t have to deal with noise and environmental regulations. If I get it on a dyno I will post that map. Top speed hitting the rev limiter in 5th,Īnd power wheelie ability in 1st will go here. Please be clear on if this is verified as in you rode it, or speculative secondhand.Įverything I do I will post instructions and pictures, If you have heard of somebody achieving gains please comment. If you have achieved any significant gains please comment. I will slap a turbo and nitrous on this bad boy just to spite you. If you intend to tell me it’s pointless and I can only expect a small performance increase then you are a negative Nancy and you can just go ahead and eat my shit. I will not let Triumph get the last laugh. I came from a CBR300R and thought the 900 was going to be nuts, I’m disappointed and will not rest until this bike is DTF. possible camshaft, crankshaft and other more exotic changes Sprocket changes with the objective of more torque.ĥ. Power commanders type attachments and mapsĤ. Join me on my journey of modifying my Street Twin to make it as powerful as possible (without doing a complete engine swap) Here we will be exploring, and modifying my,

Pimp my ride mod for gta iv eflc